This are the error messages Arduino: 1.8.15 (Windows 10), Board: 'Arduino Nano 33 BLE' I have upgraded to new Arduino Nano 33 BLE. If(!display.I was using Tic 500 Stepper motor controller with my older Arduino Nano and it was working just fine. SSD1306_SWITCHCAPVCC = generate display voltage from 3.3V internally Static const unsigned char PROGMEM logo_bmp = #define NUMFLAKES 10 // Number of snowflakes in the animation example #define OLED_RESET -1 // Reset pin # (or -1 if sharing Arduino reset pin)Īdafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET)

Declaration for an SSD1306 display connected to I2C (SDA, SCL pins)

#define SCREEN_HEIGHT 64 // OLED display height, in pixels #define SCREEN_WIDTH 128 // OLED display width, in pixels BSD license, check license.txt for more information All text above, and the splash screen below must be included in any redistribution. Written by Limor Fried/Ladyada for Adafruit Industries, with contributions from the open source community. This example is for a 128x32 pixel display using I2C to communicate 3 pins are required to interface (two I2C and one reset).Īdafruit invests time and resources providing this open source code, please support Adafruit and open-source hardware by purchasing products from Adafruit!

Pick one up today in the adafruit shop! -> This is an example for our Monochrome OLEDs based on SSD1306 drivers. The following code should load: /*********

Wire arduino library